; ; Altos Base I/O Two - SCSI only ; This configuration file is a subset of !acs0a01 BOARD ID = "ACS0C01" NAME = "Altos Base I/O - SCSI only" MFR = "Altos Computer Systems" CATEGORY = "MSD" SLOT = EISA LENGTH = 220 ; approximate length SKIRT = NO READID = YES AMPERAGE = 3000 IOCHECK = VALID DISABLE = SUPPORTED COMMENTS="This board supplies a SCSI controller." IOPORT(1) = 0ZCF0h ;Interrupt Level Register SIZE = BYTE INITVAL = 0xxx0xxx IOPORT(2) = 0ZCF3h ;Function 'Reset/Disable' Register SIZE = BYTE INITVAL = 000000xx JUMPER(3) = 1 NAME = "E3" JTYPE = PAIRED VERTICAL = YES REVERSE = YES INITVAL = LOC(1) 0 FACTORY = LOC(1) 0 COMMENTS = "This jumper connects logic ground to chassis ground." FUNCTION = "SCSI Controller" TYPE = "MSD,SCSI" COMMENTS = "The controller on this board is configured as SCSI ID 7. It terminates one end of the SCSI bus and supplies termination power for the other end." HELP = "If the LED CR1 is illuminated then the fuse F1 is blown and the SCSI bus may not be receiving termination power. Verify that bus terminators are installed only at the end of the bus and not on any devices along the bus." CHOICE = "Enabled" LINK IRQ = 15|3|5|10|11|12|14 SHARE = "msd" TRIGGER = LEVEL INIT = IOPORT(1)LOC(6-4) 111|011|101|010|001|100|110 FREE PORT = 0Z000h - 0Z01Fh ;SCSI Control and Status SIZE = BYTE DMA = 5 SIZE = DWORD TIMING = TYPEB INIT = IOPORT(2)LOC(0) 1 CHOICE = "Disabled" DISABLE = yes FREE INIT = IOPORT(2)LOC(0) 0 ;Hold SCSI Controller in Reset