;
;*----Dataflex Design - Quadcom Modem.
;     ISA CFG Version 1.00
;
BOARD
    ID = "DELFB02"
    NAME = "Dataflex Design `Quadcom' / `Biscom' Modem"
    MFR = "DATAFLEX DESIGN"
    CATEGORY = "COM"
    SLOT = ISA8
    LENGTH = 118
    IOCHECK = INVALID
    DISABLE = UNSUPPORTED
    COMMENTS = " Asynchronous card modem supporting V21, V22, (V23) 
and V22bis protocols."
SWITCH(1) = 8
    STYPE = DIP
    NAME = "SWITCH BLOCK"
    COMMENTS = " Switch number 7 & 8 must NOT be touched (both remain OFF).\N
\N
\N                Switch Position numbers 
\N    Port:   1    2    3    4    5    6
\N    COM1:  OFF  ON   OFF  ON   OFF  ON
\N    COM2:  ON   OFF  OFF  ON   ON   OFF {Default}
\N    COM3:  OFF  ON   ON   OFF  OFF  ON
\N    COM4:  ON   OFF  ON   OFF  ON   OFF          
\N
\N            Vertical position is ON             "
    VERTICAL = NO
    FACTORY = LOC(8-1) 00011001
    INITVAL = LOC(8-1) 00XXXXXX
FUNCTION = "Internal Modem as COM1 to COM4"
    TYPE = "COM"
    COMMENTS = " This option permits you to choose a serial port address
through which the modem receives and transmits data. The Quadcom / Biscom
uses COM2 as its default, although COM1, COM3 and COM4 are available. 
Remember that each serial device MUST have its own COM address. Additionally
you should avoid interrupt clashes (the modem uses interrupt three or four,
depending on which COM port is chosen). If you use this option, be sure to
mirror this change with the slide switches on the back of the modem card (refer
to page five and appendix A of your Operation Manual."
     CHOICE = "COM1"
        SUBTYPE = "COM1"
        LINK
           IRQ = 4
           PORT = 03f8h-03ffh
     CHOICE = "COM2"
        SUBTYPE = "COM2"
        LINK
           IRQ = 3
           PORT = 02f8h-02ffh
     CHOICE = "COM3"
        SUBTYPE = "COM3"
        LINK
           IRQ = 4
           PORT = 03e8h-03efh
     CHOICE = "COM4"
        SUBTYPE = "COM4"
        LINK
           IRQ = 3
           PORT = 02e8h-02efh