;Rev   Date    Name  Comment
;------------------------------------------------------------------
;1.00  15.03.90  DM  Initial release
;
BOARD
  ID = "TCC0080"
  NAME = "American Power UPS Monitor Card model AP9500"
  MFR = "APC"
  CATEGORY = "COM"
  SLOT = ISA8OR16
  LENGTH = 100
  SKIRT = NO
  READID = NO
  COMMENTS = "revision 1.00"

SWITCH (1) = 4
  NAME = "Config Switch"
  STYPE = DIP
  VERTICAL = YES
  REVERSE = NO
  LABEL = LOC(1-4) "IO Port" "Lo Battery" "S/D Status" "AC Failure"
  FACTORY = LOC(1-4) 1010
  COMMENTS = "Note that the card ON and OFF\n
    positions are revsersed from figure."

SOFTWARE (1) =
  "The UPS Monitor Card configuration file\n
   SERVER.CFG must be created in the SYS:SYSTEM\n
   directory of the file server hard drive.\n
   It must be edited as an ASCII text file.\n
   It will contain the following statements:\n\n
   UPS TYPE=1"

;Function descriptions start here

FUNCTION = "UPS Interface"
  TYPE="COM"

  SUBFUNCTION = "IO Port"
    TYPE="COM"
    CHOICE="0x231h"
      LINK
        PORT = 231h-238h
          SHARE = NO
          INIT = SWITCH(1) LOC(1) 0
          INIT = SOFTWARE(1) "UPS IO=231"
    CHOICE="0x240h"
      LINK
        PORT = 240h-247h
          SHARE = NO
          INIT = SWITCH(1) LOC(1) 1
          INIT = SOFTWARE(1) "UPS IO=240"

  SUBFUNCTION = "Lo Bat Signal"
    TYPE = "COM"
    CHOICE = "Closed"
      LINK
        INIT = SWITCH(1) LOC(2) 0
        INIT = SOFTWARE(1) "UPS DOWN=3"
    CHOICE = "Open"
      LINK
        INIT = SWITCH(1) LOC(2) 1
        INIT = SOFTWARE(1) "UPS DOWN=3"

  SUBFUNCTION = "S/D Status"
    TYPE = "COM"
    CHOICE = "Off"
      LINK
        INIT = SWITCH(1) LOC(3) 0
         INIT = SOFTWARE(1) "UPS WAIT=15"
    CHOICE = "On"
      LINK
        INIT = SWITCH(1) LOC(3) 1
        INIT = SOFTWARE(1) "UPS WAIT=15"

  SUBFUNCTION = "AC Fail Signal"
    TYPE = "COM"
    CHOICE = "Closed"
      LINK
        INIT = SWITCH(1) LOC(4) 0
    CHOICE = "Open"
      LINK
        INIT = SWITCH(1) LOC(4) 1