; Copyright (c) TCC 1991. All rights reserved. ; No part may be reproduced, transmitted, transcribed, stored in retrieval ; system, or translated into any language or computer language, in any form ; or by any means, electronic, mechanical, magnetic, optical, manual, ; or otherwise, without prior written permission of TCC. ; ; Configuration file for the GSS AT1050 High-Resolution Video ; Display Controller by Graphic Software Systems. ; ; @[#]TCC0230 1.20 91/09/30 ;=== Maintenance History ===================================================== ; ;Rev Date Name Comment ;---- -------- -- ---------------------------------------------- ;1.20 30.09.91 TF Text edits for release. ;1.10 02.08.91 DM Added port addresses, DOS/OS2 distinction ;1.00 02.06.91 DM Initial release ; BOARD ID = "TCC0230" NAME = "GSS AT1050 Video Display Controller" MFR = "GSS" CATEGORY = "VID" SLOT = ISA16 LENGTH = 330 READID = NO COMMENTS = "File revision 1.10" SOFTWARE(1) = "The GSS adapter has been configured with the system resources listed below. This information may be necessary when you run the HWCONFIG program. Note that the DMA channel and IRQ level are only significant if you are running the OS/2 BusMaster Presentation Manager driver." FUNCTION = "GSS AT1050 Display Controller" CONNECTION = "The high resolution analog monitor must be connected to the 15-pin DSUB connector, labelled JP6, on the rear bracket.\n\nIf a separate VGA adapter is installed in the system, it may be connected to the pass-through connector, labelled JP4, on top of the GSS adapter.\n\nNote that pin 1 of the pass-through connector is oriented towards the rear bracket." SUBFUNCTION = "Software Mode" COMMENTS = "The GSS AT1050 adapter can operate in two different modes. For standard MS-DOS and OS/2 drivers, the adapter will use programmed IO through port addresses 1CCh - 1D8h.\n\nThe OS/2 BusMaster Presentation Manager driver requires a different set of resources. These resources include a DMA channel and an optional IRQ level.\n\nTo change the specific resource used, select the Change Resource command. If you do not wish to enable an IRQ level for the GSS adapter, select Resource Option Set #2." CHOICE = "Standard MS-DOS and OS/2 Modes" FREE PORT = 1CCh - 1D8h SHARE = NO INIT = SOFTWARE(1) "\tPORT = 1CCh - 1D8h" CHOICE = "OS/2 BusMaster Mode" FREE PORT = 1CCh - 1D8h SHARE = NO INIT = SOFTWARE(1) "\tPORT = 1CCh - 1D8h" LINK DMA = 0 | 3 | 5 SHARE = NO TIMING = TYPEA INIT = SOFTWARE(1) "\tDMA = 0" | "\tDMA = 3" | "\tDMA = 5" SUBCHOICE LINK IRQ = 10 | 11 | 15 SHARE = NO TRIGGER = EDGE INIT = SOFTWARE(1) "\tIRQ = 10" | "\tIRQ = 11" | "\tIRQ = 15" SUBCHOICE FREE INIT = SOFTWARE(1) "\tIRQ not enabled" SUBFUNCTION = "Memory Size" COMMENTS = "The optional memory expansion board must be installed on the GSS adapter before running the HWCONFIG program.\n\nThe four 33 Ohm SIP resistor packs must be moved one pin to the right if the memory expansion board is installed. The resistor packs are located on the top left corner and labelled S1 - S4. \n\nPlease refer to the manual for diagrams regarding this modification." CHOICE = "Standard" CHOICE = "Expansion Board Installed"