;Western Digital WD1007A-WAH Winchester Controller
BOARD
	ID	= "WDT0005"	;?Temporary ID
	NAME	= "Western Digital WD1005-WAH Winchester Controller"
	MFR	= "Western Digital"
	CATEGORY= "MSD"
	SLOT	= ISA16		;
	COMMENTS= "\nInterfaces two ESDI-compatible hard disk drives.  Before 
		  installing verify proper termination of the last hard disk 
		  drive.  The last drive (and only the last drive ) requires  
		  a termination resistor.\n"	;
	HELP	= "\n\n"	;?

JUMPER(1) = 1
	JTYPE		=PAIRED
	NAME		="W1"
	VERTICAL 	=YES
	REVERSE		=YES
	INITVAL		=LOC(1) 0
	COMMENTS	="No jumper setting is standard.  A jumper setting is 
		a special test setting for Original Equipment Manufacturers."
JUMPER(2) = 1
	JTYPE		=PAIRED
	NAME		="W2"
	VERTICAL	=YES
	INITVAL		=LOC(1) 0
	COMMENTS	="No jumper setting is standard.  It enables
			translation.  It is the MS-DOS compatible setting.
			A jumper setting disables translation."

JUMPER(3) = 1
	JTYPE		=TRIPOLE
	NAME		="W3"
	VERTICAL	=NO
	
	LABEL		=LOC(1)	"3-2-1"
	FACTORY		=LOC(1)	1
	COMMENTS	="A jumper on 2-3 selects a primary address range of
	1F0-1F7 for the port address for the disk.  This is the standard 
	setting.  A jumper on 2-3 selects a secondary address of 170-177.  This 
	is the setting for a secondary controller."


SOFTWARE(1) = "If the 'Translation Feature' is enabled, Western Digital's 
	Advanced Diagnostics program, Setup and WDFMT must be run before
	the DOS programs FORMAT and FDISK.\n\n"
FUNCTION	= "Fixed Disk Controller"
TYPE 		= "MSD"
HELP		= "Use E)dit Change R)esource to Select Options"
CONNECTION = "Cables:\nConnect the 34-pin control cable to J4 connector and
the hard disk drive.\nAttach a 20-pin data cable to J2 connector(for Drive 0)
and connect to proper hard disk drive.\nAttach a 20-pin data cable to J3
connector(for Drive 1) and connect to proper hard disk drive.\nAttach 
Winchester activity LED connector to J1." 

CHOICE = "Disk Address Options"
LINK
	PORT = 1F0h-1F7h|170h-177h
	INIT = JUMPER(3) LOC(1) 1|0