;
;  zds video card
;
BOARD
  ID = "ZDSF010"
  NAME = "ZDS Video Card"
  MFR = "VID"
  CATEGORY = "VID"
  SLOT = ISA16
  LENGTH = 240			      ;HEIGHT = 102
  SKIRT = NO
  READID = no
  AMPERAGE = 500
  DISABLE = UNSUPPORTED
  IOCHECK = INVALID
  
  COMMENTS = "This Board is the standard ISA video Controller.
	      The board itself is a standard ISA device.
              (Configuration version 1.05)"
  HELP="This is the Board Identification Block help field
	for a Video Controller Board Slot Type ISA8OR16.
	This is a standard ISA product, and this operation is used to
	initialize the AT-Compatible CMOS.    (Configuration version 1.05)"

JUMPER(1) = 2
   NAME = "Tripole Jumpers"
   JTYPE = TRIPOLE
   VERTICAL = YES
   REVERSE = YES
   LABEL = LOC(1-2) "E1" "E2"
   INITVAL = LOC(1-2) 01 
   FACTORY = LOC(1-2) 01 
   COMMENTS = "The video board jumper block is configured at the factory and should
not change."
   HELP = "The E1 Jumper set enables the IRQ 2 the bus.  A connection
between pins 1 and 2 represents the enabling of the IRQ of the card.
However, a software system is also needed to complete the IRQ 2 enable.
Jumper E2 cannot be changed.  The E1 and E2 jumper sets should not be used 
in this video board."


SWITCH(1) = 8
  NAME = "BACK PLANE SWITCHES"
  STYPE = DIP
  VERTICAL = YES
  REVERSE = NO
  LABEL = LOC(8-1) "S8" "S7" "S6" "S5" "S4" "S3" "S2" "S1" 
  INITVAL = LOC(8-1) 00000000
  FACTORY = LOC(8-1) 00000000
  COMMENTS = "These switches are not enabled in this version of the 
video card.  Some later versions may not even contain them at all.
The user should just leave them off!"
  HELP = "If your board does not contain this switch block do not
be alarmed.  In later revisions of this board, the switch block may
be removed.  The switches are not used on this board, and the settings
have been included here as a courtesy to the user."

FUNCTION = "VIDEO Board  Internal"
  TYPE = "VID"
  HELP = "VIDEO Function and Initialization Parameters\n
	  Inherent to the video board.  These functions\n
	  cannot be changed."

  CHOICE = "Version 1.05"
    FREE

      PORT = 03B7h - 03Dfh  ;Video ports
      PORT = 0102h	;VGA setup port
      PORT = 46E8h	;VGA enable port
 
      MEMORY = 64K ;Video Memory 
	ADDRESS = 0A0000h
	WRITABLE = NO
	MEMTYPE = SYS
	SIZE = BYTE
	SHARE = No

      MEMORY = 64K ;Video Memory 
	ADDRESS = 0B0000h
	WRITABLE = NO
	MEMTYPE = SYS
	SIZE = BYTE
	SHARE = Yes

      MEMORY = 32K ;Video ROM  
	ADDRESS = 0C0000h
	WRITABLE = NO
	MEMTYPE = SYS
	SIZE = BYTE
	SHARE = NO
	CACHE = YES