;
;  zds video card
;
BOARD
  ID = "ZDSF038"
  NAME = "ZDS VGA Video"
  MFR = "ZDS"
  CATEGORY = "VID"
  SLOT = ISA16
  LENGTH = 240			      ;HEIGHT = 102
  SKIRT = NO
  READID = no
  AMPERAGE = 350
  DISABLE = UNSUPPORTED
  IOCHECK = INVALID
  
  COMMENTS = "This Board is for a standard ISA video Controller.
the board itself is a standard ISA device.  (Configuration version 1.05)"
  HELP="This is the Board Identification Block help field
for a Video Controller Board Slot Type ISA8OR16.
This is a standard ISA product, and this operation is used to
initialize the AT-Compatible CMOS.  (Configuration version 1.05)"

JUMPER(1) = 1
   NAME = "IRQ 2 Jumper"
   JTYPE = PAIRED
   VERTICAL = YES
   REVERSE = YES
   LABEL = LOC(1) "J1" 
   INITVAL = LOC(1) 0 
   FACTORY = LOC(1) 0 
   COMMENTS ="The J1 Jumper set enables the IRQ 2 the bus.  A connection
between the pins allows the enabling of the IRQ of the card.  However, a 
software system is also needed to complete the IRQ 2 enable.  The J1 jumper 
should not be used in this video board.  The video board jumper block is 
configured at the factory and should not change."

SWITCH(1) = 8
  NAME = "Reserved Switches"
  STYPE = DIP
  VERTICAL = YES
  REVERSE = NO
  LABEL = LOC(8-1) "SW8" "SW7" "SW6" "SW5" "SW4" "SW3" "SW2" "SW1" 
  INITVAL = LOC(8-1) 00000000
  FACTORY = LOC(8-1) 00000000
  COMMENTS = "These switches are not enabled in this version of the 
video card.  Some later versions may not even contain them at all.
The user should just leave them off!"
  HELP = "If your board does not contain this switch block do not
be alarmed.  In later revisions of this board, the switch block may
be removed.  The switches are not used on this board, and the settings
have been included here as a courtesy to the user."

FUNCTION = "VIDEO Board  Internal"
  TYPE = "VID"
  HELP = "VIDEO Function and Initialization Parameters\n
	  Inherent to the video board.  These functions\n
	  cannot be changed."

  CHOICE = "Version 1.05"
    FREE

      PORT = 03B7h - 03Dfh  ;Video ports
      PORT = 0102h	;VGA setup port
 
      MEMORY = 64K ;Video Memory 
	ADDRESS = 0A0000h
	WRITABLE = NO
	MEMTYPE = SYS
	SIZE = BYTE
	SHARE = No

      MEMORY = 64K ;Video Memory 
	ADDRESS = 0B0000h
	WRITABLE = NO
	MEMTYPE = SYS
	SIZE = BYTE
	SHARE = Yes

      MEMORY = 32K ;Video ROM  
	ADDRESS = 0C0000h
	WRITABLE = NO
	MEMTYPE = SYS
	SIZE = BYTE
	SHARE = NO
	CACHE = YES