Article: Q51323
Product(s): See article
Version(s): 2.20 2.30 | 2.20 2.30
Operating System(s): MS-DOS | OS/2
Keyword(s): ENDUSER | | mspl13_basic
Last Modified: 12-APR-1990
The following steps can be used to create an assembly listing of a
program with CodeView:
1. Begin CodeView in sequential mode by using the /T command-line
switch.
2. Specify a listing file to redirect CodeView output to by typing the
redirection operator ">" followed by a filename at the dialog
prompt. You may redirect the output directly to a printer by
specifying the printer after the ">" (e.g., >PRN).
(Note: From this point on, commands will not be viewable.)
3. Use the Unassemble command "U" to disassemble the code and send a
listing of the program to the output file. If you do not specify
the starting address and the range to unassemble, CodeView will
unassemble the next eight lines of code. See the CodeView
documentation for more information on the Unassemble command.
You can use this method on any files, whether or not they contain
CodeView information. In this regard, you can create assembly listings
of programs that were not created with a Microsoft compiler. Please
also note that you cannot create assembly listings of instructions
other than 8086 instructions.