Article: Q96331
Product(s): Microsoft Disk Operating System
Version(s): MS-DOS:6.0,6.2,6.21,6.22
Operating System(s):
Keyword(s):
Last Modified: 22-NOV-1999
-------------------------------------------------------------------------------
The information in this article applies to:
- Microsoft MS-DOS operating system versions 6.0, 6.2, 6.21, 6.22
-------------------------------------------------------------------------------
SYMPTOMS
========
After you upgrade to MS-DOS 6.x, you may receive the following message if you
are using Stacker:
WARNING: Unrecognized load high method. Unable to verify driver fit
The driver loads successfully, but you must press a key to continue.
CAUSE
=====
This message occurs if you use a DEVICEHIGH= command for the Stacker device
drivers in your CONFIG.SYS file. It does not occur if you use a DEVICE= command.
WORKAROUND
==========
To work around this problem, ensure the command for SETVER.EXE is located above
the Stacker device drivers in the CONFIG.SYS file. To do this, SETVER.EXE must
be located on the uncompressed Stacker partition.
1. Copy SETVER.EXE to the uncompressed drive. For example, if your compressed
drive is C and the swap drive is D, copy SETVER.EXE to drive D as follows:
copy c:\dos\setver.exe d:\
2. Put the following SETVER.EXE statement at the top of your CONFIG.SYS file:
device=c:\setver.exe
3. Restart your computer.
The product included here is manufactured by a vendor independent of Microsoft;
we make no warranty, implied or otherwise, regarding this product's performance
or reliability.
Additional query words: 6.22 6.00 6.20 2.0 2.1 2.x 3rdparty
======================================================================
Keywords :
Technology : kbMSDOSSearch kbMSDOS621 kbMSDOS622 kbMSDOS620 kbMSDOS600
Version : MS-DOS:6.0,6.2,6.21,6.22
=============================================================================