PRO6J

MANUAIS DE MOTHERBOARDS JBOND

Pro6J

Slot 1 for Intel Pentium II & III and Celeron
VIA VT82C691 and VT82C596 Chipsets.
SMC FDC37M602 Power Multi I/O Chip.
Dimensions: 9.5 inches x 7.2 inches Mirco ATX form (support ATX case).
Award PnP PCI flash BIOS.
Three 168-pin DIMM sockets.
Two Enchance IDE sockets (up to four IDE devices) support fast ATA-2, ATAPI, and Ultra DMA/33 functions.
One Floppy socket supports two floppy drivers with 360K, 720K, 1.22M, 1.44M, and 2.88M bytes.
One AGP slot supports x1and x2 AGP card.
Three PCI slots. (PCI spec. V2.1)
One ISA slot. (1 PCI/ISA shared slot)
PS/2 keyboard and PS/2 mouse connectors on board.
Two Serial Port sockets.
One Parallel Port socket supports SPP, EPP, and ECP.
Two USB Port connectors on board.
One FIR (Fast IrDA) Port connector on board (transfer rate up to 4MB/s).
System hardware health monitor.
Modem wake-up function to switch system power on.
LAN wake-up function.
Automatic frequency reduction in case of CPU overheating.
Creative(TM) SB Link ready function.
On-board CMI8330 3D Sound Chip.

1. CPU Jumper Settings

Note:

2. Clear CMOS Data Jumper Settings

Operating Mode	CLS1
Normal Operating (default)	Short 1-2
Clear CMOS Data	Short 2-3 while computer powered OFF

3. Support DIMM Module List

Each DIMM socket supports 4M to128M bytes (for 16Mbit technology) or 8M to256M bytes (for 64Mbit technology) DIMM module.
Vcc provides 3.3v
Support SDRAM-II, SDRAM and EDO DIMM modules.

4. (Optional) On board Sound Chip Jumper Settings

5. (Optional) MIC IN Select Jumper Settings

6. Support Year 2000 Compliance

7. Support LS-120/Zip Driver Boot Function

8. Support SCSI/CD-ROM Function

9. Support INT 13 Expansion Mode (control above 8.4 GB IDE Hard Disk)