TechnoSoft I/O Utilities for DOS version 1.0

The utilities in this program are included to help you as a user
manipulate your computer more efficiently.

The main menu will appear as follows:

TechnoSoft I/O Utilities


  [1] Set keyboard typematic rate
  [2] Disable keyboard until a time
  [3] Set password & wait for entry
  [4] Reinitialize floppy drives
  [5] Reinitialize fixed disk drives
  [6] Park fixed disk drive heads
  [7] Recalibrate fixed disk drive
  
  [9] Copyright Notice
  [0] Exit program

Type your choice: _

At the menu, you can choose any of the functions by pressing the number next to it
in brackets. A description of each appears below.

NOTE:  If you have not yet registered, you are reminded that this program is a
       15 day evaluation version.  You can find instructions on registering in
       the READ.ME file.

NOTE:  Once you register the program, you are reminded that you may only distrib-
       ute the UNREGISTERED version.

**[1] Set keyboard typematic rate

   You can use this to set the delay and repeat rate of PC AT and PS/2 keyboards.
   Just follow the prompts that pop up.


**[2] Disable keyboard until a time

   You can use this to disable the keyboard for a length of time.  Note that this
   can be gone around by turning your computer off then on again, or by pressing
   the reset button.


**[3] Set password & wait for entry

   This command allows you to type in a password, after which it clears the screen
   and waits for the password to be typed, followed by the enter key.  This disables
   your keyboard until the password is entered, and like the above function can be
   overcome by resetting the computer.


**[4] Reinitialize floppy drives

   This command resets your floppy drives after drive errors, or if you suspect
   something strange happened to them.


**[5] Reinitialize fixed disk drives

   This, like the above, resets your drives, but only does the fixed disk drives and
   not the floppy drives.


**[6] Park fixed disk drive heads

   This command is good to use if you will be moving your system or subjecting it to
   any kind of shocks (impacts).  After it is run, it is suggested you *immediately*
   shut off your computer to preserve its state.


**[7] Recalibrate fixed disk drive

   Like command #5, this resets your fixed disk drives, and can be used if command
   #5 fails to work.  If this command fails to work, it is suggested that your bring
   your computer in to see a specialist.


**[9] Copyright Notice

   This shows you the program's copyright notice.  Please read this over before using
   this program.


**[0] Exit program

   One of the more obvious commands, it exits the program! (Duh!)
   

